Tractor Talk Discussion Board |
Re: Can it be done safely
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy as in Randy-IA on February 04, 2007 at 11:58:39 from (207.177.83.174):
In Reply to: Can it be done safely posted by old on February 04, 2007 at 10:32:10:
Hi Old , Don't you have a big power shovel type loader ? Put the ball in the bucket lip and back it in IF the loader weighs equal to the load and has 4 wheel brakes ! I moved a smallish job trailer 10x30 a couple years ago with our JCB teleboom ( about 15,000lbs , rear steer , 4x4 ) on flat pavement , no problems but I could sure tell I had a load on ! Only moved it about half a mile through town to get it off the jobsite for one of the subcontractors . We tried a F450 but bent the hitch . Multiple trailer axles make it very hard to turn also . Don't do it . Hire someone with the right equipment . Or rent a heavy dozer . $500 bucks is small change compared to a wrecked trailer or dead operator . ...Randy
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|