Tractor Talk Discussion Board |
Re: rod bearings for John Deere D
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Skip 33652 on February 04, 2007 at 17:08:57 from (66.115.250.253):
In Reply to: rod bearings for John Deere D posted by the flying belgian on February 04, 2007 at 16:36:32:
what is the matter with the ones that were in the tractor they are reusable unless they are in terrible condition. the next bet is good used ones that you should be able to find. new ones exist but are going to be very expensive .watch e-bay they do show up. If the babbit is bad in the ones you have they could be rebabbited.probably $100 a rod. and if you are really a pefectionist new ones can be made expensive.a D will run a long time on bad crank and bearings I have a couple that are shot and run great.Paul
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|