|
Tractor Talk Discussion Board |
Re: tightening fan belt on SUPER A
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by gene bender on February 06, 2007 at 08:45:52 from (67.55.226.214):
In Reply to: tightening fan belt on SUPER A posted by al bane on February 06, 2007 at 08:21:54:
the inner nut next to the head is not supposed to turn. You need a wrench that fits on the fan shaft in FRONT of the bracket. Now after 50 pluss yrs that nut on the back side may turn as it could have been replaced or rounded off or who knows. Anyhow that is the way it is supposed to be as it fits in a slot. Use a bar or something that can be used to raise the pulley assy up and hold while you get the fan shaft tightened. Helps to release the tension on the gen then retighten when finished with fan belt.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
