Tractor Talk Discussion Board |
Re: OT,, CBs and antennas
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim in NC on February 07, 2007 at 19:05:28 from (172.162.183.205):
In Reply to: OT,, CBs and antennas posted by ChadS on February 07, 2007 at 17:48:10:
You need to tune the antenna to your Radio. You will need a SWR meter(standing wave ratio). It is not hard to do. The purpose is to match the antenna length to the signal wavelength being transmitted or received. The meters are not expensive, and you may find one at Radio Shack. I know you could find one on line. During this process, you will either lengthen or shorten the antenna. Make sure all your coax connections especially at the connectors are good-no shorts or loose wire.. I have messed with these things since the early 70s. I don't talk much anymore since most of my radio buddies have passed away. I still have tbe base station set up as well as mobiles in the vehicles. They do come in handy on trips. Some radios have swr meters built in them like my base radio, but I don't think yours has one. I can tell you how to check it if you decide to do it yourself. Also, your antenna should be mounted on or near a flat surface away from vertical objects such as other antennas. Most antennas that I have tuned tend to be adjusted to the shorter side. If I had to tune one without a meter, I would shorten it as much as possible and see if someone will give you a radio check, then lengthen a little and see if it is better. A low swr will also help your reception as well. A really good antenna is worth the money if you will be using it alot. Hope this helps.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|