Tractor Talk Discussion Board |
Re: Briggs old style recoil clutch problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gene Davis (GA) on February 18, 2007 at 17:07:34 from (75.104.46.143):
In Reply to: Re: Briggs old style recoil clutch problems posted by Oldmax on February 18, 2007 at 16:55:16:
When this type of starter Briggs starter clutch is squealing it usually means the end of the extended paret of the crankshaft that goes into the square part of the clutch is dry. The best cure is to take clutch off and lightly grease the shaft with a good lubricant and then reassemble it all. The hole in the end of the clutch mechanisim is for putting a drop of oil into if the engine is vertical and it does the same thing, just doesn't last as long. Sometimes the rope will back out of the recoil when it gets dry enough. Also kee the balls clean and their compartments dry and free from dirt or trash.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|