Tractor Talk Discussion Board |
Re: OT..3PT loader
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RWK in WI on February 21, 2007 at 16:54:57 from (69.95.234.22):
In Reply to: Re: OT..3PT loader posted by matthies on February 20, 2007 at 19:25:48:
We have a Gnsue 6 foot rear loader on a 3 cyl. Ford 2000. The unit also has a Ford front snowplow. It is a good unit for snow plowing. We plow the straight road sections with the front blade and the rear loader stacks when backing up in clearing the turn arounds and also stacks the bank the county plow leaves at the end of the driveways. The county plows with a road grader with a wing blade so those banks are high.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|