|
Tractor Talk Discussion Board |
Re: OT: Horse Fencing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on March 03, 2007 at 04:47:35 from (205.188.117.14):
In Reply to: OT: Horse Fencing posted by John Van Valkenburgh on March 02, 2007 at 20:54:51:
If they crib, that top board will get chewed up quickly, but then again, I have not found a good solution for that, just keep buying rough sawn 1x6's from the local sawmill. That seems like a shallow depth, good compaction around the post would help. We have some areas that you can't get down too deep, a few feet and hardpan, rock, or shale, makes it a pain to keep a gate post secure, unless you pour some concrete around it, frost heave is always a problem, every year, a lot of the fence posts have to be re-set, pack the hole with stones, to fill tha gap around the post from them leaning on it. The paddock with the electric line, stays straight for the most part, and they are not shy about going through the gate, but like Allan says, once they are spooked at something, they don't soon forget. You might try dry packing the posts with gravel mix, straight portland mixed with the soil or something cementitious, containing portland, it will tighten the soil around the post, but at that depth, around here, if frost were to get under the dry packed area, it will give it surface area to push on. Without the frost, should help keep em straight, couple shovels full of portland mixed with the soil, pack tightly, next rain, water em down yourself, will be tight.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
