Tractor Talk Discussion Board |
Re: Axle Housing/Center Section Assemblies (Gasket
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Oldmax on March 13, 2007 at 05:15:58 from (24.154.143.101):
In Reply to: Axle Housing/Center Section Assemblies (Gasket) posted by Pete, IL on March 12, 2007 at 10:38:10:
I don't believe in using liquid gasket of any kind except when surface is damaged to the point that it has to be used for temporary repair untill cases can be repaired or replaced to do job right. If you clean surface properly & use a new gasket you shouldn't have trouble with leaks . On the job "Before retirement" for 30 years I worked on gear boxes and I found that Using the gasket that gearbox was designed for give a lot better service than liquid gasket material I always looked at it as a temporary fix or quick fix most pros don't use it .
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|