|
Tractor Talk Discussion Board |
2 point - 3 Point Conversion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Robert Searcy on March 20, 2007 at 19:20:59 from (70.13.72.239):
Dilema = What do I buy? I just purchased a 1959 Farmall 560 Diesel with a two point fast hitch swinging drawbar. I see there are some bent type slide in fast hitch arms with 3 point balls on the end you can reverse from narrow to wide to fit cat 1 and cat 2 equipment. I also see there are straight arms with just category 2 ends. I also see they make these quick hitch units that go on as well that hook to the 3 point ball ends. Anyone have experience with any of these. I plan to use my 560 with a 6.5 foot rotary mower, bale spike and tiller, all of which are 3 point. Suggestions?? My biggest concern would be that when I use the slide in arms are implements going to be normal distances so that my PTO shafts for my rotary mower and tiller will work. I had been using them on a John Deere A with a category 2 3 point kit. Thanks,
Robert
Replies:
Home
| Forums
Today's Featured Article -
Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
