Tractor Talk Discussion Board |
Re: Massey Fergusen 35 Gas??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glen in TX on March 31, 2007 at 10:11:17 from (208.246.9.139):
In Reply to: Massey Fergusen 35 Gas?? posted by Terry Roemer on March 31, 2007 at 09:36:44:
So you have good flow of clean fuel to carb. Is there a screen fitting on inlet of carb bowl? Some may have that and some won't but check there next to make sure not plugged screen. Might try squirting some carb cleaner in just inlet on carb or even WD-40 as needle may just be gummed up sticking and if that doesn't work pull it apart and put in another kit. Just be sure to check the float if it is fuel laden or collapsed replace it since new floats are available reasonably. Make sure float isn't bent rubbing on sides of carb bowl also. Can check the float for leaks by holding it in a pan of hot water (not boiling) with a pair of pliers and if any leaks will see air bubbles spewing out at leak.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|