Tractor Talk Discussion Board |
Re: O/T Question - What are the purpose of lightni
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brian G. NY on April 05, 2007 at 07:52:14 from (64.246.155.113):
In Reply to: O/T Question - What are the purpose of lightning r posted by Turke Bros. Farms on April 05, 2007 at 07:16:00:
There was lightning protection on every building (including the chicken house) at a place where I used to live. One day as I was sitting at the kitchen table, lightning struck the combination weather vane/lightning rod on the end of the barn right in full view about 150 ft. away. First of all when lightning strikes that close there is no waiting to hear the thunder as it is simultaneous with the strike. Real scarey! Anyway, there was a shower of sparks at the rod but when I went out to check the ground cable, it was as cool as a cucumber. This system had been installed in the 40s and everything used in the istallation was made of copper including the nails and straps and the grounding wire was real heavy gauge. I often wondered if lightning would have hit the barn if the rod had not been there? I once worked on a prison farm here in NYS and one afternoon lightning struck a huge maple tree where we had two freshening cows pasturing. Of course they were under the tree to escape the rain. Both were killed instantaneously. The ends of the roots popped right out of the ground and the tree was split down the middle but it survived. We had our own slaughtering plant so we called a couple of the inmate butchers out and butchered the cows so it was not a total loss. Lightning is powerful stuff!
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|