|
Tractor Talk Discussion Board |
Re: Removing cylinder sleeves
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pajamafied John on April 13, 2007 at 06:19:03 from (68.55.81.179):
In Reply to: Removing cylinder sleeves posted by MTrimOhio on April 12, 2007 at 18:25:40:
You can make a puller easy enough. 3/4" allthread, washers, nuts, and a heavy chunk of barstock on either end with 13/16" or so holes in the center. The bottom barstock must be sized to fit the outside of the sleeve but not interfere with other block parts. Use wood on the underside of the barstock on the deck side. Works perfect.
Replies:
Home
| Forums
Today's Featured Article -
Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
