Tractor Talk Discussion Board |
Re: O/T, Any body have a cheap easy way to cut roc
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RMinVa on April 13, 2007 at 17:59:08 from (209.145.80.144):
In Reply to: O/T, Any body have a cheap easy way to cut rocks posted by old on April 13, 2007 at 14:08:04:
I've seen stone buildings and bridges in my area that were built by slaves. Have also seen the tools they used but never seen them used. This rock was cut out of the Staunton river just below Long Island Va. I've seen the notches they made in a line along the rock. It's a slight V shape notch. They would cut pieces of wood and shape the end to fit the notch in the rock and make it a little over size. They would dry the wood stake with heat/fire to shrink the wood. Once dried they would drive the V shap stake in the notches and the river water would swell the wood and the rock would break along the notches. It's some beautiful work. There's one arch bridge over a creek about 75 yards from the river and then there's the bridge that crossed the river. The big bridge has a rock ramp and the pillows is all that's left. Our southern troops burned that bridge when leaving Appomattox. They didn't know the surrender had been signed. They had orders to burn every bridge they crossed. There's also a rock road from the bridge to the houses on the Campbell Co. side which is about 1 mile from the river. Just thought I'd throw in a little history of how it was done back then. And I'm sure different type of rock is done different ways. This is all brown rock and seems to break straight. Only place I've seen rock like this is in the river bed.
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|