Tractor Talk Discussion Board |
Re: OT - Thinking about drilling a well
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Handyman on April 15, 2007 at 19:49:20 from (63.239.240.1):
In Reply to: OT - Thinking about drilling a well posted by two mile on April 15, 2007 at 11:35:08:
having worked on a cabletool rig at one time I can say that the rotarys are much faster, but if they find a crack in the rock they have a tendancy to follow it where a cabletool will just keep going straight down. I was working on a couple of irrigation wells at one point and the guys who were going to install the pumps came out and were greatly relieved to find a cable rig doing the job. they had to set a 14 inch pump inti a 16 inch hole just the week before that was drilled by a rotary rig and they had literally had to screw the entire set into the ground to a depth of 80 feet.
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|