Tractor Talk Discussion Board |
Re: Since jlmtractor asked a basic question...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul from MI on April 19, 2007 at 17:14:07 from (66.231.36.33):
In Reply to: Since jlmtractor asked a basic question... posted by Mike CA on April 19, 2007 at 13:21:40:
Generally seeds will not germinate unless they are in tight contact with soil. Plowing loosens the soil and turns under the residue from the previous crop leaving the soil surface bare. Discing breaks up the soil into small particles to give good contact with the soil. It also levels the plowed surface to some extent, although other tools sucha s harrows will do a better job of leveling. Then when seeds are planted either packer wheels or antoher implement such as a cultipacker or roller compact the soil around the seed for good germination. Cultivators were used to remove weeds between the rows of row planted crops, such as corn. Corn was somretimes "check" planted so that cultivation could be done in two directions, thus eliminating weeds in the rows. This is the method used prior to the advent of herbicides in the 1950"s. They eliminated the need for cultivation and allowed plant populations and yields to greatly increase. After the herbicides came "no till" planting which eliminated plowing and discing. Why turn over 40" of soil to plant a seed in 2"? This bring us to the current farming practices, which are variations of these. There are so many different variations that many books could be written, but herbicides made it all possible. Just my opinion and faulty memory, Paul
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|