Tractor Talk Discussion Board |
Re: OT: Power stroke glow plugs ??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by New Holland Tech on April 22, 2007 at 10:58:18 from (161.184.192.57):
In Reply to: OT: Power stroke glow plugs ?? posted by Kelly C on April 22, 2007 at 08:33:50:
Try waiting 20 or 30 seconds after the light goes out before cranking the engine. Our '97 F350 service truck was doing the same thing, even when trying to start it inside the shop; 2 or 3 trys before it would start. But, just as an experiment, I waited for around 20 seconds after the light went out before cranking it over. Aha! Started right up. I hope this works for you. Lyndon
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|