Tractor Talk Discussion Board |
Re: What about the center support columns
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on April 27, 2007 at 14:43:25 from (64.12.116.14):
In Reply to: What about the center support columns posted by Pooh Bear on April 27, 2007 at 13:04:15:
I think you answered your own question there. You could certainly use temporary shoring, to transfer the loads from the column you want to take out, then rebuild, steel column on a footing, might save a little labor, make sure you check and coordinate the elevations, footing below new slab or isolation joint around the footing if top of footing is to be same as top of slab elevation. That certainly is quite a bit of work after the house is up, one of the reasons I always tell people to think and plan out first, because doing it later is always more work and costly. Lots of times things change after the fact, but whenever possible good to explore the possibilities prior to, because sometimes it's so much more to do it later. With all the smaller equipment available today, something that would be safe to use in confined quarters, makes you wonder if there is a micro excavator,somehow direct the exhaust to the outside via a flex hose, and some sort of conveyor you could use to send the excavated material outside. I'd be knocking a hole in that foundation and be digging my way in, unless it were sand, cannot imagine doing it by hand, but I'll bet theres a lot of homes in this country where that was done. That 3D model and the floor plan is a nice tool, is that a simple software to use ? Makes a nice tool for figuring things out.
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|