Tractor Talk Discussion Board |
Re: wiring
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by caterpillar guy on April 29, 2007 at 16:58:52 from (152.163.100.14):
In Reply to: wiring posted by Dave in Tx on April 29, 2007 at 06:43:45:
sounds like the pos. &neg cables are on backwards otherwise the pos. cable goes on the top or bolt farthest from the starer motor on the solenoid and the rest should be obvious by size of eye on wire or the wire about the size of a #12 will go on with the bat. cable and the smaller one will go on the bolt off to the side one will make it click and the other will act like it"s just dead . make sure all wire ends and threads are clean and the little copper piece from the bolt out the side of the starter housing is on the sloenoid bolt closest to the starter it"s self . Hope this helps . If not mail me and go from there .
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|