|
Tractor Talk Discussion Board |
hydra Touch with Fast Hitch Hydraulic Problem. Dra
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by hbf4 on May 03, 2007 at 19:03:33 from (67.186.152.140):
My IH 240 has a two point hitch with a hydraulic piston controlled by a lever on the right side of the seat. A couple of weeks ago one of the metal lines that runs from the hydra touch valve under the gas tank to the mounting block under the seat started leaking, and I ended up cutting the metal line, and using a compression fitting. I bypassed the mounting block, and ran a hydraulic hose to the sylinder. Now the cylinder will raise the drawbar, but the cylinder won"t lower the drawbar. If I disconnect the lines, the sylinder will retract. Any suggestions would be welcome.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
