Tractor Talk Discussion Board |
no float without correct valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tx Jim on May 10, 2007 at 03:54:49 from (4.253.78.253):
In Reply to: Re: hydraulics posted by midwest redneck on May 10, 2007 at 02:45:45:
midwest redneck,if I'm understanding your post I disagree with your statement about open-center valve in center position will allow blade to "float". My hyd. experience comes from agriculture field not industrial field. If cylinder is a two-way cylinder and is pinned solid on both ends the only way rear blade can float on a open or closed center valve is if control valve has a detented "float postion" If your refering to blade attached to 3pt hitch,very few brands of tractors will not let blade float no matter if it's open or closed-center as the 3pt has no "down pressure" on most brands. Tx Jim
Replies:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|