Tractor Talk Discussion Board |
Re: Water in hydraulic/transmission fluid
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hal/WA on May 17, 2007 at 23:17:01 from (66.45.175.118):
In Reply to: Water in hydraulic/transmission fluid posted by Jrry on May 17, 2007 at 10:20:12:
A few years ago, I changed all the fluids in my 641D. It sits outside and they all showed some evidence of being contaminated with water. Then last year, I started having trouble with my hydraulic system. The oil was milky, so I changed it. About a month later, it was milky again. I needed to do some work on the PTO and decided to drain the rear end oil before removing the PTO shaft. About the first quart of liquid that drained out was water, and the oil was very contaminated. It also appeared to be quite overfull with the added water. I replaced the oil and now keep the top cover covered with canvas, since it had to be rain water getting in the rear end case and the only logical place I could see that it could be doing that is around the spring. No more problems with the hydraulic oil getting milky and I hope the water in the rear end lube didn't do too much damage in that area. If you retain the milky hydraulic oil in a can, eventually the water mostly settles out to the bottom of the can. I reuse the hydraulic oil after the water settles out. One pretty good way of keeping the water in the settling container is to let it freeze and then to pour the oil into another container, leaving the ice behind. If you continue to have contamination, you might want to check the rear end. Apparently the seals between the 3 compartments aren't the best, at least on my tractor. Good luck!
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|