Tractor Talk Discussion Board |
Re: '53 Moline UMIL help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by HeatherW on May 28, 2007 at 15:12:12 from (66.112.12.26):
In Reply to: Re: '53 Moline UMIL help posted by Unimog on May 28, 2007 at 15:00:59:
ok, called my dad and got some #'s off the tractor. He said on the tag it says UMIL on the right side of the transmission there is the tag with the tractor # on it which is 05700026 On the engine is the serial # which is 05600026 and then there is 340-B on the same tag. hope this helps some on the looking up of the tractor.... from these numbers we had came up through searching this site and the mm collectors club that there was only 42 of them built......there is also a book that we'd found that this one was #27 of the 42....
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|