Tractor Talk Discussion Board |
Re: Leaky hydraulic ports
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Cliff Neubauer on May 31, 2007 at 05:10:07 from (69.66.91.175):
In Reply to: Leaky hydraulic ports posted by IaGary on May 31, 2007 at 04:39:07:
If you pull the rubber dust seal off the front (there should be a snap ring holding it in) and the 5/16" bolt out of the back the coupler you can take the coupler out to check the seals. I don't know how it could have happened but I had one that got a little corroded which let it drip like your saying. Also there are two rubber seals that are like square shoulderd o-rings that seal the coupler in the housing that could be bad. Those ISO conversions aren't as reliable as the factory setup but they sure beat having to use adaptors. Between our 5488, 1086 and three 1066s we have them all changed over to ISOs and it seems like about once a year one will start leaking like yours are.
Replies:
Home
| Forums
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|