Tractor Talk Discussion Board |
Where to drive?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by flying belgian on June 28, 2007 at 07:03:48 from (207.13.162.217):
Tractor pulling wagons. 2-lane state hyway. blacktop shoulder not quite wide enough for wagons. Is it better to drive completely in driving lane or stay as much on shoulder as possible? When I stay on shoulder as far as I can cars can get by me if I don't weave at all but that is pretty hard to do pulling 2 loaded wagons. So they come up on me top speed and think they can get by me. About that time I weave a little and they swerve over into oncoming traffic. Oncoming taffic than swerves off onto their shoulder, lays on the horn and gives everybody the finger. Then car passing me looks back and gives me the finger. If I drive fully in the driving lane traffic backs up sometimes 10 deep. then when there is a break in oncoming traffic they pass me and half of them give me the finger for taking up the driving lane when I should be on the shoulder. Back wagon is painted bright orange with cospicuity tape, 2 smv's and flashing lites so I have as much right to be on hyway as autos and trucks. Had a close call yesterday that is why it is on my mind today.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|