Tractor Talk Discussion Board |
OT: ‘73 Chevy C-30 Dump Truck Hydraulic Pump Cable
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Blur3992 (N Illinois) on July 01, 2007 at 19:36:54 from (172.162.171.94):
I recently picked up a 73 Chevy C30 with a dump bed on the back. The bed is hydraulically lifted, with a PTO powering a hydraulic pump. Right now, there is no way to control the pump. There's a lever on the pump that has about 4 inches of travel, going two inches either way from a center detent. Also, there is a small 3/4-inch hole in the floor near the shifter. I assume that there is supposed to be a control cable that mounts in the floor to connect to the lever on the pump. Is there a specially built cable for this sort of thing? The thickest control cable that Farm and Fleet had was still pretty flimsy. I know I could probably make it work, but it would be nice to have the proper part.
Replies:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|