|
Tractor Talk Discussion Board |
Lesson Learned... The Hard way
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by L.C.Gray on July 05, 2007 at 05:56:41 from (208.193.186.117):
Got me some education the hard way. Sometimes little things happen that lead up to an accident. They don't seem like a problem at the time, but let someting change in the formula and you'll get bit!
I did the p'rade thing yesterday. I had the '34 C all dolled up including a big red white and blue bow on the front. After the p'rade I elected to road it back across town to the trailer at the staging area. On the way there it started getting hot, so I stopped to remove the bow from the front to help it cool. The bow was tied on the bail that holds the cap on. While trying to undo the bow the bail flipped and the cap blew off with a violent eruption of antifreeze. Shouldn't have happened on an un-pressurized system.
Someone before me had made a gasket for the cap, I guess to keep it from slobbering and making a mess, but theres still an overflow tube right? I haven't looked yet, but I'm nearly sure what got me. We have an insect around here that loves to nest in any hole it can find in anything. It always packs both ends if its nest with mud. They can be quite stubborn to get out, sometimes requiring a ram-rod or digging it out when even high pressure air won't dislodge them.
I never thought the gasket could lead to that problem, but I never thought of the possibility of the overflow getting plugged up either. I wound up spending part of my Independence Day captive in the ER. I had burns on my right hand and arm, worst was on my hand where the glove was soaked and I just couldn't get it off fast enough. Its all bubbled up nicely.
I did learn though.... I'll be checking the drain tubes occasionally, and that gasket is history!
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
