|
Tractor Talk Discussion Board |
Re: Hydraulic Motors
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on July 05, 2007 at 06:50:14 from (4.154.244.114):
In Reply to: Re: Hydraulic Motors posted by Wardner on July 05, 2007 at 06:21:34:
Just reread your response. Oil return is via original hose. Not sure of cycle times. Air compressor has a 9 cubic in displacement Charlynn gear-roter. I haven't powered it up yet. I may swap in a 4.7 cubic in similar motor. The Getec is an engineered product. The generator currently turns at 2200 rpm at engine idle. Will have to use a hand throttle to achieve 3600 rpm. I think reservoir is about ten gallons. I changed the oil last fall but can't remember how much I put in. Every thing on the multi-function forklift works fine so far. It even functions as a forklift. I'm adding the air compressor now. It is surprisingly nimble without the counter weight. Capacity is down to about one ton now.
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
