Tractor Talk Discussion Board |
Farmall 504
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wild Bill Caldwell on July 05, 2007 at 18:37:02 from (67.33.116.31):
I asked y'all about a Farmall 504 Diesel a few days ago, Long story short, I bought the tractor. It's a 1964, so I didn't expect not to have to do some work on it. First off, it's missin' one piece of sheet metal. As you can see from the photo, it's the piece that goes under the steering column, below the instrument panel and bolts to the sides. Any ideas where I'd find this piece of sheet metal. Also I need the gauges. None work. Need tach. Where do I find gauges and tach? Glow plugs don't work, I have to start the engine with starting fluid. I need all manuals that are available. From reading posts on YT, some say that some manuals are not what they should be. I don't remember the names, maybe JEN something. I would appreciate a reccomendation on manuals and where to find them. 3 point hitch is a little slow. Where do I check hydraulic fluid, add hydraulic fluid, and what hydraulic fluid should I use? I've looked the tractor over pretty good, the only dipstick I can find is for the engine oil. Thank Y'all Wild Bill Caldwell
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|