Tractor Talk Discussion Board |
To Allan In NE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by C-man on July 10, 2007 at 08:51:25 from (69.77.252.119):
We are here in South Dakota (about 50 miles west of Pierre) cutting wheat. Or I should say we WERE cutting wheat. Got almost an inch of rain yesterday evening. VERY welcome moisture on everything but the wheat. We got to 115 degrees on Saturday. Makes for good combining. We started combing for a friend on June 30 and have been going steady since then. Kind of needed a break though. We did 2 "custom" jobs and we have since moved on to our own. With the spring and winter wheat, we have about 1100 acres to do with one 1680 Axial flow combine. With 5100 hrs. on the machine, we are thankful for every day we are able to go without a breakdown. As for moving down the road, don't you just hate that. We were moving down a heavily traveled highway on the 3rd of July. Everybody was in a BIG hurry to get to their vacation destinations. We had the header off the combine and on a trailer, so we were not blocking anyone's "progress". A small Chevy Blazer passed us and went a few miles down the road where 3 of the occupants got out to answer "nature's call" I went by them just as they were getting back in their vehicle. When they came back on the highway, they passed me with no problem and one of the young lads leaned out the window and gave me the one finger wave. I only got the first three digits of the liscense plate. I wish I could have gotten it all so I could have got into contact with them somehow to see what I did to deserve their wave. Most of the locals are fine, it seems the one's that are in a hurry have Rapid City, Aberdeen or Sioux Falls plates on their vehicles.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|