Tractor Talk Discussion Board |
Re: trouble
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ed1 on July 13, 2007 at 09:41:25 from (198.185.164.128):
In Reply to: trouble posted by Farm All Newbie on July 13, 2007 at 08:02:38:
Sounds like fuel. All you have is a tank, glass bowel, line and carb. Starting with the easiest things first like the little girl who said to the truck driver stuck under the bridge - why dont you let the air out of your tires which reduced the height of the truck and got him unstuck Do you have enough gas and is the valve under the tank all the way open. Ok assuming that wasn't your problem Disconnect the fuel line from the carb and let it run into a can. Good Flow Yes/No ??? If YES, check the carb adjustments richen up the fuel mixture but If its the carb and no one touched the stetings it's rebuild time - or you could just clean it up yourself as it's probably some crud that needs to be blown out. If NO, remove the gas cap as sometimes the fuel cap's vent gets clogged and will stop the flow. If no flow after the cap is off then remove the glass sediment bowel under the gas tank and clean it our. With an air hose blow out the gas line then reinstall the bowel and blow out the line again. Becareful - not too much pressure. Do you have flow? if yes reconnect the fuel line to the carb and start r up. In not remove the fuel line and bowel assy from the tank their is a plug of crud somewhere that needs to be removed.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|