|
Tractor Talk Discussion Board |
Re: Gooseneck Trailer Axle Positioning
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Weltz on July 21, 2007 at 16:38:12 from (167.142.225.157):
In Reply to: Re: Gooseneck Trailer Axle Positioning posted by MN Scott on July 21, 2007 at 16:33:10:
Believe me, if I could afford a new, heavier trailer, I would already have one. Either way, this trailer pulls great and I have an Air-Ride hitch for it so that is not the problem. Once the axles are bridged I will have no more problems there either so my only concern now is the tires. As stated I like the lateral stability of duals but am unable to keep them on this trailer and thus need to go to wider singles. What do you guys think would be a good size? I have 16x6 rims and would like to stay with them but also have a set of 16x6.5 that could be used if I had to. Let me know. Thanks!!!
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
