Tractor Talk Discussion Board |
Re: Defective new part
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by doug in illinois on August 03, 2007 at 16:44:29 from (207.144.221.131):
In Reply to: Defective new part posted by MTC on August 02, 2007 at 20:19:22:
Defective new parts are no surprise to me. I go thru a lot of brakes on my mail route, at any given time I have 3 sets on the shelf. I would guess the failure rate in the first week of mailroute at about 10 percent. After that they are OK until they wear out. Always the same failure, regardless of where I got them. It is usually on a Monday, when I have the weekend mail along with a big fat boxholder everybody gets and the car is honestly overloaded. What happens is the pad shucks right off the backing. Happens with any grade I use. Not enough glue to stand the heat or riveted too loose to stand the extreme braking. Also had a tractor tire tube I ordered from an EBAY seller that took over a week to get to me, when I received and installed it leaked like a sieve. Never did find all the leaks, patched 4 and still leaking. At that time I got the clue tube pure junk. Bought one locally, no problem with it at all. Junk one was Korea made, local one USA. Finally got replacement tube from internet seller, think I will air it up and see if it holds air better than the one they sent me before. If it does will keep in case I need it, otherwise just going to pitch it. Oh, regarding the brakes, I can't even guess where they are made. I have one set here that does say Hecho En E U A, which I do think means made in USA, the rest say distributed in USA. We need to take our country back, the bad part is even a lot of the USA made is by illegal workers.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|