Tractor Talk Discussion Board |
Re: OT moblie home pulling
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NE IA Dave on August 04, 2007 at 12:48:29 from (12.215.72.223):
In Reply to: OT moblie home pulling posted by james in mo on August 03, 2007 at 16:17:08:
Just to make you think before you die. No way in heck should you try this with a M. We busted a draw bar on a 1486 and bent one on a 4020. If all is well, these tractors should work, but when a trailer house gets in time with the bumps in a HWY it is to much for the drawbar. We always move them with all household stuff in place. I think by the time you drop the trailer behind your M and get to the roadway you will understand real fast what negative messages here advise. Seems a farmer thinks his tractor is a little more than it truley is. You will need a 2 5/16 ball, and your M will probably need a litle torch work to make the hole larger. A AC 190 also needs to have the hole inlarged as a general rule. A 1486 probably will fit. If you chose a M (or any tractor for that matter) make sure that the nut on the ball is tight. Many balls have been used on thicker drawbars and the threads are stripped. If so washer it up as the shaft will snap if it does not draw down tight. The jacks are usualy welded or bolted stable and do not go up real high, so your tractor drawbar best not bend down to much. This is not important on a road, but once you get in a yard and it is a little soft you get in trouble fast. Dual wheels add to the stability, but limit you on turns, as the trailers have little tounge length. A 806 to 1486 will best be fitted with front end weights if any extreem hills are involved. Like said elsewhere hills take on alot of different profiles.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|