Tractor Talk Discussion Board |
Re: Tubeless tires on tube type rims
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ACEd on August 09, 2007 at 05:48:41 from (65.5.210.56):
In Reply to: Tubeless tires on tube type rims posted by Tim in NB on August 08, 2007 at 16:53:20:
As said above, tires same except for inner liner (and tighter tolerance fit on beads to seal better) - some early tube type tires actually has vents in bead area to allow air between tire and tube to escape. Rims same if made since mid 50's unless riveted or otherwise made up. Newer rims same size & shape but generally better metallurgy to eliminate porosity. If you go back to 30's rear rims were slightly different geometry but newer tires work - just look odd. Biggest problem with tubeless is prone to leak if rims are rough or rusty at bead or if there is rust in center at welds or if tire bead is damaged. Advantage to tubeless (car and truck tires primarily) is they generally do not go flat for common nail puncture and they are easier to mount. Big deal on car / truck tires is to use a special radial tube for radial tires as they flex different. Secrets to mounting with a tube - put just a little air in tube to unfold it and stretch it out a bit - not enough to make it round - but remove valve core. Mount 1 side of tire, put tube in carefully to avoid pinching, mount top of tire carefully to avoid pinching, inflate, let air out being careful not to lose valve stem back into tire / rim hole - there is a $2 tool for this - this will let air between tire & tube escape, then reinflate.
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|