Posted by John T on August 18, 2007 at 04:48:59 from (66.244.83.147):
In Reply to: polarize posted by noidea on August 17, 2007 at 21:18:31:
You Polarize by momentarlily flash jumping NOT any permanent "taped" attachment.
NOTE DO NOT FLASH JUMP TO THE GENNYS FIELD POST ONLYYYYYY ITS ARM POST
On a 2 wire Cutout Relay system that would be to just momentarily flash jump the cutout relays BAT input and GEN/ARM output together and you should get a spark. Same things accomplished by flashing the relays BAT terminal direct down to the Gennys ARM post.
NOTE for Polarization to work the gennys Field post needs a ground current return path so you can temporarily dead ground the gennys field post to case/frame when you do the flash. It should already have a ground via the Low/High charge setting in the light switch and the field needs a ground current return path for it to charge you know which is dead grounded for high charge but via a resistor in the Low/High light switch for Low charge.......
Is the ammeter wired correct polarity??? If not it will register bass ackwards. If its wired correct if you turn on lights or ignition engine NOT runnig it should swing over to - discharge but then swing to + charge when running iffffffff the genny is working.
Was the tractor changed from Pos to Neg ground?????????? That would explain a backwards working ammeter unless its leads were swapped. The genny can still charge at EITHER polarity but the ammeter needs corrected and the coil (if it has one) needs leads swapped also as its somewhat polarity sensitive.
If shes charging the lights should glow noticeably brighter from slow idle to fast RPM and the batery voltage should rise from 6.3 volts to around 6.5 to 7 on a 6 volt system and double that on a 12 volt system. If that happens perhaps shes charging okay and its had a battery polarity swap and maybe all it needs is the ammeter leads reversed (check coil polarity also)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
