Posted by Ed65 on August 18, 2007 at 19:16:57 from (75.88.146.172):
Thank you for taking your time to help. I am looking for a used hydrolic pump drive for a 1966 JD400 backhoe. The part number is T22915T. The dimensions are: 4 and 3/16 in. long. The center point of the two hoses on the front part of the drive measures 2 and 3/4 inches. My problem is that I bought an after market part, but the part is too long and there is not enough room between the pump face and the engine drive. The after maket part has the correct part #, but it is at least 1/4 inch longer that he original part. I have called everywhere that I know of and I cannot find a used one. All I can find is the after markert part that is too long. Since the backhoe is so old, I thought I could find one fairly easily. I can't shave the front or the back end down to make it fit because it will make the unit too thin at both points. The pump size is 3.01 cu. inches. I would greatly appreciate any info. on where I may find a used one. John Deere wants over $200 for the part and the after market is $85. Thanks for your time. Ed
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
