Try a local equipment dealership, their not terribly expensive new. That said if your in really dusty conditions spend the extra and get one of the centrifugal cleaners with the spinning paddle in the top. I've got a customer that does rock drilling and blasting. His are subjected to ALOT of fine dust so all of the machines all had a precleaner. They were using the plastic bowl type on them so as a test I converted one of them to the centrifugal type. It made a huge difference in filter cleanliness and therefore filter life, and at $100+ for the filter that made a huge difference in filter replacement cost and they paid for themselves within two changes. Needless to say all of his machines now run the centrifugal cleaners and are better for it. I don't have a link handy but I can tell you the ones I used on his machines are made by Century. Their made completely of stainless and have a lifetime warranty. The first one I put on has been in service for nearly 5 years and still looks as good as one I just put on awhile back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.