Posted by David, Surrey UK on August 29, 2007 at 13:13:00 from (84.9.75.186):
In Reply to: LED Trailer Lights posted by JPatton on August 24, 2007 at 19:52:28:
I don't know much about trailer lights, but coming from an electronics background I can tell you a bit about the LED devices themselves.
There are a number of variables. First, the efficacy (lumens per watt) can vary; some devices are inherently brighter than others. This depends on how they're made.
Second, the emission angle varies. Incandescent bulbs emit light in all directions, but LEDs tend to beam it out in a narrow beam. The narrower the beam, the brighter the light appears, but if you go off beam the light intensity dies away quickly. In practice you want a reasonably wide beam so you can be seen from all angles. The LED itself is encased in a plastic lens, and sometimes these are clear, other times translucent. The translucent ones spread the light over a wider angle but this makes them look dimmer.
Third, in a practical application like trailer lights, the LED device will probably be behind some sort of protective plastic optics, which will further affect the way the light behaves.
Fourth, the amount of light put out depends on the current passing through the LEDs. But since the eye has a logarithmic response, doubling the current won't double the apparent brightness. Too much current and the LEDs will have a short life.
Fifth, a single LED is almost a point source, but to be visible from a distance you want a large illuminated area, hence lots of LEDs are needed.
I don't suppose that's very helpful, but it's background info!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.