Posted by rrlund on August 31, 2007 at 09:57:40 from (216.46.211.138):
In Reply to: Removing broken bolts posted by 37 chief on August 30, 2007 at 23:31:38:
I've tried it with limited success. But let me tell you something that my son learned at auto deisel college. For removing pipe plugs from castings,blocks,transmissions,rear ends etc...WAX. Wouldn't have believed it if I hadn't done it myself. Just heat the area,press a candle of other block of wax against it. The heat will pull the wax into the threads and lubricate them. I had a plug in a rearend housing that I'd tried everything with,practically had it ruined with a chisel. He told me to heat it again while he went in the house and got a candle. He pushed it up against it then said let it cool a little. I did,then took a chisel and barely tapped it. It spun right around and I turned it out with my fingers. Try it,it works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
