Posted by soundguy on September 05, 2007 at 13:11:07 from (12.64.6.21):
In Reply to: Losing Proposition posted by Not Me on September 05, 2007 at 12:06:42:
Here's what i would do.
try to contact the 'person responsible' again.. let them know that you are interested in that 'thing'.. that you would show up and move it with your own labor, they can watch without getting their hands dirty, and offer them a 20$ (dinner) or a 50$ ( dinner and a movie ) for allowing you to take it off their hands. That sort of thing has worked for me many times when i wanted a piece of junk setting in someone's pasture that they didn't want but weren't interested in hauling off either..
If that is not feasable, try again with the coal company.. Don't go too high up the food chain.. hit a supervisor onsite perhaps.. a grounds forman.. somebody with enough authority to say 'yes'.. but not so high of a pay grade that they lay awake and worry about personal liability and illegal dump issues.. etc. Try the same 'grease' as in the other situation. Unless the guys' well ta do.. who can't use an extra 50$ to take the wifey out.. or buy some school clothes for the kids.
If you can get square with that guy.. let him watch you load it.. and you both say thanks and never see each other again.
Take a friend with you..1, it's your labor helper, and 2, makes a good witness in the very unlikely event of '6mo down the line a 'theft' issue comes up.' For your end, your witness see's a legit businees deal.. some money changes hands.. scrap is hauled off.. and everything is on the up and up..
I think your main stumbling block is the presence of the dump seems to be taboo.. and everyone is trying to stay upwind of it... and got scared when you asked questions.
Remember the green grease and offer to bring your own labor and transportation that way it is fast & easy 1-2-3 for them. If you go the corporate route offer to sign a liability release IF they ask you to.. I doubt they will.. This will probably be a 'record-less' transaction....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
