Should be fine. I wouldn't add Standyne or PS. Bio-diesel has been shown to be a far better lubricant that either of those. 2% provides about 1/2 the wear as compared to using Stanadyne or PS. If you don't have Bio available, mix in 2 cycle oil to a ratio of 100:1 to 200:1. The study I saw was for 200:1 ratio and wear reduction was nearly as good as 2% bio (about 50% better than stanadyne or PS.)
The study is here and is from dieselplace. A good read and worth the 15 min.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.