Posted by Dennis Genereau, Jr. on September 14, 2007 at 11:19:16 from (136.234.34.226):
In Reply to: OT: building a flue posted by mark on September 14, 2007 at 08:11:34:
My brother is a licensed contractor here in Minnesota. I asked him your question and this is what he told me. Assuming you are burning wood or coal, the chimney must be three feet above the ridge if it comes out of the ridge. If it comes out below the ridge, you have two options. The first is to bring it up until it is three feet above the ridge, which would make the most sense if the chimney comes out just below the ridge. The second is a little more complicated, and applies to chimneys that come out near the bottom of the roof. First, you have to bring the chimney up high enough so that if you ran a horizontal line across the top of the chimney towards the roof, it would travel 10 feet before it would the touch the roof. Then you have to go three feet above that. In other words, if your roof has a 12/12 pitch (45 degree), your chimney would need to be 13 feet above the roof line where it comes out (10 feet to the horizontal line, then three above that). The lower the pitch, the lower the chimney. In all cases though, once you are three feet above the ridge line, you are high enough. It does not matter whether your chimney comes through the roof or up the side. He was not sure what the specs were if your heat source is gas or oil.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
