Posted by migraine on September 25, 2007 at 09:12:52 from (67.182.151.248):
In Reply to: Gonna Be A Long Day posted by Allan In NE on September 25, 2007 at 07:15:46:
Looking Good there guy. What about getting some real light weight angle sheet metal from freight company or heating company to lay in the corners or what about the expandable foam that you put out of the can and fills in all the little holes. Those 16' grain boxes are setting all over eastern Washington. Must have seen 100 older trucks just setting there. Most were used to haul wheat to the elevators or potato and onion harvest and the mechanics went out of the trucks but the boxes look good. BIL is just starting to make a new bed for his because he need 18' and did not find many of those. Old trucks were priced from 1500 up. By the way did you get the Hydro 70 motor redone and what did you find in there? Later Migraine
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
