Posted by soundguy on October 04, 2007 at 07:24:23 from (12.65.24.201):
In Reply to: Kodiak posted by David Case on October 03, 2007 at 11:24:43:
Kodiak seems to be a tad cruder than KK in the weld dept.
I've had no problems with the older 'red' KK equipment for say.. 6-7 years ago. i've had no experience with the yellow KK equipment .
In that price range also look at howse.
A 96 hp tractor can pull a 15' mower..... If it were me.. I'd get an 8' or a 10' mower at least.. you can get those as 3pt. the 8' and 10' will be dual spindle, and will probably pull better than 7' single spindle mowers.
I have a howse 10' 3pt mower.. I pull it with a ford 5000 ( 70hp ) as well as a NH 7610s that is about 95hp.. etc.. though I like a 15' batwing behind my 7610s.. etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
