Posted by djfarmer on October 11, 2007 at 13:46:17 from (69.179.11.199):
In Reply to: Frustrating posted by Dave from MN on October 11, 2007 at 11:32:33:
I have built a number of large structures on my property over the years got a permit once, never heard a thing. Last year I set some posts to put up a 63x40 pole building, had no intention of getting a permit. With just a few posts in the ground I got a letter stating that I was being fined for not getting a permit. I wanted to tell them that I was only putting up a really tall fence but I thought that they might not believe me and check up on me latter. So I went down to the court house to face the music. Turned out that the fine was that I had to pay double the cost to get the permit $150 instead of $75. Half expected they were going to lock me up. Not that I care all that much about $75, but I figure that I am still way ahead based on all of the permits that I forgot to get in the past.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
