Posted by kyplowboy on October 23, 2007 at 17:34:56 from (63.146.226.90):
Sorry guys, I need to get on my soap box here. Hauled my old bull off yesterday to the local sale barn. The guys there have all ways been first rate. This bull had lived at my house for 5 years and had never seen a hot shot, whip or even a tobacco stick. I loaded him with half a 5 gallon bucket of soy hulls that he ate on for the first 15 miles of the trip. I unloaded him and he started walking down the ally way there and this punk azz brat started walk'n behind him crack'n a bull whip. Now I have never seen any one at this place do anything like that before and the more I think about it the madder I get. I ain't a bunny hugger or nothing but why would a place like that have a punk kid do'n that where people could see him. I pulled around and watch the guy behind me unload and punk did the same thing to a load of 6 calves. If they can not build facilities to work cows with out a whip or can't hire hands smarter than the cows should I find a new sale barn? Should I call or wright the owners and tell them why I am not come'n back? What are yall's ideas here?
Thanks for letting me vent.
If any one from around here reads this, it was at the West KY Livestock Market in Marion KY in case you were wonder'n.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
