Posted by Glenn FitzGerald on November 07, 2007 at 15:46:02 from (216.56.24.226):
In Reply to: Re: Tamin' The Beast posted by Allan In NE on November 07, 2007 at 14:47:25:
Very interesting experience/testimony!
My memories of an Allis Chalmers combine aren't so favorable. As a kid growing up in the 60's we had a pto driven A/C 66 direct cut. The machine was in excellent condition as we maintained it well and always kept it shedded when not in use. However the two most distinct memories I have of it are: unplugging it and greasing it. The unplugging was an ongoing and frequent occurance. As I remember it, greasing was an endless task best suited for a monkey. The contortions one had to get into to access grease fittings remain etched in my mind forever. Dripping with sweet in Wisconsin's hot August weather with chaff dropping in your face only adds to the memories. None of us four boys nor my 90+ year old father have any idea where that peice of family history currently resides and hopefully we never will. Let's just say, we're not looking for it.
In fairness, I'm sure a couple significant factors contributing to our negative experience were the fact that the only tractors we had to pull it with for most of its years were simply not geared low enough and lacked live pto. Combine that with a little too much greenery in the standing oats crop and the stage was fully set for a three-ringed-circus.
On the other hand, years later we had an F Gleaner which served us very well. The Gleaner is a good machine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.