Posted by the tractor vet on November 08, 2007 at 19:13:46 from (99.167.214.202):
In Reply to: Super MD that misses posted by Gerald Culverwell on November 08, 2007 at 16:23:57:
If ya have a miss in and old gas start diesel and ya say that the head has been redone then ya had best be looken for a crack in the sleeve along with a crack in the block, the crack will run up and down between three and four . Most of the ones that i have found have been between two and three but have found them on other cylinders. Drove me and a buddy plum nuts tryen to find the miss on his MD as we had two missen one bad miss on three and a slight miss on 2 . End up boring the block and pressen in repair sleeves and reboring for the std. sleeves . YA got to remember just how old these engines are and how many times that they have been heated up and cooled down and Stress cracks start . It is it's way of relieving it's self.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.