Posted by LarryO on November 09, 2007 at 06:07:16 from (142.46.8.6):
In Reply to: will not start posted by pieceofjunk on November 09, 2007 at 05:54:55:
I have a '99 with the 24 valve. Had a problem last winter where it quit on me. What I had to do is first bleed the system at the fuel filter (make sure it is full). Then I went up to the injection pump and made sure the feed line was air free. Then I went to just one of the injection lines and opened it up at the injector and repeatedly turned engine over. For what seemed for hours, only bubbles came out, then all of a sudden it started catching. I tightened the injector and turned it over a while longer and it caught. I'm not sure if this is what a mechanic would advise but it did get mine going. Also, make sure if your lift pump is manual that the handle is in before you try cranking the engine over. Good luck. Lar
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
