Posted by OliverGuy on November 11, 2007 at 14:09:27 from (74.132.11.45):
Sorry, way off topic. I asked this question a year or so ago and got some good starting points, but am wondering if any one has any other ideas. I get a very large pile of brush, debris, etc. ground up each fall to use for mulch the following year for our company. The end pile is typically 400-600 cubic yards. This pile will begin to breakdown and heat up to 120-130 degrees from two weeks after it is ground till I pull it apart in the spring. It doesn"t matter what temperature it is outside. In the past, it"s been zero out and 1-2" in the pile it"s over a 100 degrees already. Have any ideas on how to harness all this heat/energy to heat either the shop or home or ? I know it needs to be hot to get the wood to begin to break down and "color" so it looks better in the spring to sell, but it sure seems like there is a lot of heat there to use. Normally the pile is 300" from the shop and farther to the house. I can move it though to make it closer. Just wondering if any one could point me in the direction of some info or if you have any ideas. Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
